The supporting roller is the basic accessory of the tumble dryer, but if there is a problem with the supporting roller, it will also affect the efficiency of the drying production line. The following is the correct adjustment method of the supporting roller summarized by the editor.

The adjustment of the support roller should be based on the rotation direction of the cylinder. And it is necessary to adjust the center line of the supporting wheel, adopting the method of tilting the supporting wheel in one direction at the same time, forming an angle of less than 0.5 degrees with the center line of the cylinder to prevent the wearing and deformation of the supporting wheel. It is necessary to make the supporting wheel have a spiral upward reasoning, so that the dynamic force of the rest of the cylinder is basically balanced, so that the simplified body can run in a relatively stable position, that is, the tire belt can freely reciprocate between the upper and lower retaining wheels. In the process of adjustment, in order to make the cylinder move up, we suggest that it is better to put some lubricating oil on the surface of the support roller, which can increase the mocai on the surface. On the contrary, if you want to make the cylinder slide down, you can apply some lubrication Grease is used to reduce the friction force on the surface. When adjusting the supporting rollers, adjust the four supporting rollers at the same time, and ensure that the contact surface between the tire belt and the supporting rollers is not less than 50%.

You can adjust the supporting roller through the above methods. If the supporting roller is damaged, it should be replaced in time to avoid more serious consequences.